Equipment
| Item | Location |
|---|---|
| 4 wheel cart that ejects ball vertically | Set 7, Cabinet 2, Shelf 2 |
| Ball to be ejected | Set 7, Cabinet 2, Shelf 2 |
| Metal slug (actuates trigger on cart) | Set 7, Cabinet 2, Shelf 2 |
| Ramp for car | Set 7, Cabinet 2, Shelf 2 |
| Piece of Foam | Set 7, Cabinet 2, Shelf 2 |
| 2 C-Clamps | Clamp Station |
| Wooden Board | Set 1, Cabinet 1, Top of Cabinet |
| Duct Tape | TLC Desk |
| 2 Lecture Benches | Room 3, Room 5, or prep area |
Set-up Instructions:
1. Place ramp on the far edge of one of the benches and fix it to the table using duct tape.
2. Place the metal slug approximately 14 inches from the end of the ramp and fix in place using a piece of duct tape bubbled to the back.
3. Slowly guide the car down the ramp and over the slug to insure that it is placed in such a way that it will actuate the trigger on the ball; adjust position accordingly.
4. Fix the wooden board to the far edge of the second bench with the C-clamps. Place the foam in front of the board to act as a bumper during the demonstration.
5. Locate the red arrow on the ball. Align the ball so that the red arrow is on its underside, pointing in the direction OPPOSITE of the car's intended motion. Push down on the spring, and manually set the trigger on the underside of the car.
